C Specification

To dynamically set the line width, call:

// Provided by VK_VERSION_1_0
void vkCmdSetLineWidth(
    VkCommandBuffer                             commandBuffer,
    float                                       lineWidth);

Parameters

  • commandBuffer is the command buffer into which the command will be recorded.

  • lineWidth is the width of rasterized line segments.

Description

This command sets the line width for subsequent drawing commands when the graphics pipeline is created with VK_DYNAMIC_STATE_LINE_WIDTH set in VkPipelineDynamicStateCreateInfo::pDynamicStates. Otherwise, this state is specified by the VkPipelineRasterizationStateCreateInfo::lineWidth value used to create the currently active pipeline.

Valid Usage
  • VUID-vkCmdSetLineWidth-lineWidth-00788
    If the wide lines feature is not enabled, lineWidth must be 1.0

Valid Usage (Implicit)
  • VUID-vkCmdSetLineWidth-commandBuffer-parameter
    commandBuffer must be a valid VkCommandBuffer handle

  • VUID-vkCmdSetLineWidth-commandBuffer-recording
    commandBuffer must be in the recording state

  • VUID-vkCmdSetLineWidth-commandBuffer-cmdpool
    The VkCommandPool that commandBuffer was allocated from must support graphics operations

Host Synchronization
  • Host access to commandBuffer must be externally synchronized

  • Host access to the VkCommandPool that commandBuffer was allocated from must be externally synchronized

Command Properties
Command Buffer Levels Render Pass Scope Supported Queue Types

Primary
Secondary

Both

Graphics

See Also

Document Notes

For more information, see the Vulkan Specification

This page is extracted from the Vulkan Specification. Fixes and changes should be made to the Specification, not directly.

Copyright 2014-2021 The Khronos Group Inc.

SPDX-License-Identifier: CC-BY-4.0